TESTING AND ADJUSTING C-3 C-3 [E233] Disconnection in PC-EPC solenoid system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code "E" is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check that the service code "E" is displayed. (If it is not displayed, the problem has been removed.) # If there is a disconnection in the solenoid or wiring harness, no current flows to the solenoid. If the No.
2 pin of the solenoid is short circuiting with the chassis ground, the current (approx. 1A) continues to flow to the solenoid. # Always turn the pump prolix switch OFF. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on to the next step. Table 1 Table 2 20-177 YES 2 Is resistance 4YES between C02 YES (female) (8) and (18), Is resistance between (18) and chassis as YES H12 (female) (3) and shown in Table 1? (5), (4) and (7), (3) (4) 3 (5), (7) and chassis as 1 • Turn starting switch Is resistance shown in Table 2? OFF.
Is resistance • Disconnect C02 between H12 (male) • Turn starting switch NO b (1e )t w ane de n ( 2C ),1 (3 2 )( m ana dle) NO ( c3 h) a a sn sid s ( a4 s) , s ( h4 o) wa nn d in • O DiF sF c. onnect H12 Table 1? • Turn pump prolix chassis as shown in Table 1? • Turn starting switch switch OFF • Turn starting switch OFF. NO • Disconnect H12 OFF.
• Disconnect C13 NO Cause Remedy Defective engine throttle, pump controller Defective contact or disconnection between wiring harness between C02 (female) (8) - H12 (5) or short circuit with chassis ground, defective contact or disconnection in wiring harness between C02 (female) (18) - H12 (7) - C05 (female) (2) Defective pump prolix switch (internal disconnection, defective contact, short circuit with chassis ground) Defective contact or disconnection in wiring harness between H12 (3) - C13 (female) (1), or short circuit with chassis ground, defective contact or disconnection in wiring harness between H12 (4) - C13 (female) (2) Defective PC-EPC solenoid (internal disconnection, defective contact) Replace Repair or replace Replace Repair or replace Replace Troubleshooting1 Troubleshooting2 Troubleshooting3 Resistancevalue BetweenC13 (male)(1)and(2) BetweenC02 (female)(8)and (18) BetweenH12 (male)(3)and(4) 10-22Ω BetweenC13 (male)(2)and chassis BetweenC02 (female)(18)and chassis BetweenH12 (male)(4)and chassis Min.1MΩ Troubleshooting4 Resistancevalue BetweenH12 (female)(3)-(5), (4)-(7) Max.1Ω BetweenH12 (female)(3)(4)(5) (7)andchassis Min.1MΩ