TESTING AND ADJUSTING C-5 C-5 [E213] Disconnection in swing holding brake solenoid system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code "E" is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check that the service code "E" is displayed.
(If it is not displayed, the problem has been removed.) # Always turn the swing lock prolix switch OFF, then turn the swing lock switch OFF before checking. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on to the next step. Table 1 20-181 3 YES Go to A Is resistance YES between C01 (male) 2 (3) and chassis as shown in Table 1? Is resistance YES between V04 (male) • Turn starting switch NO ON 1 (1) and (2) normal? • Disconnect C01 Interchange • Turn starting switch connector with other OFF solenoid. Is [213] displayed?
• Disconnect V04 NO • 20 - 60 Ω • Turn starting switch OFF • Interchange V04 with NO other solenoid • Turn starting switch ON 6YES Is voltage between YES V04 (female) (2) and 5 chassis as shown in Table 1? Is resistance YES between X05 • Turn starting switch NO (female) (3) and (4) ON 4 normal? • Disconnect V04 Is resistance • Turn starting switch A between X05 (male) OFF (3) and chassis as • Disconnect X05 NO shown in Table 1? • Max.
1 Ω • Turn starting switch ON • Disconnect X05 NO Cause Remedy Defective engine throttle, pump controller Defective swing holding brake solenoid (internal disconnection, short circuit with power source) Defective contact or disconnection in wiring harness between V04 (female) (1) and chassis ground Defective contact or disconnection in wiring harness between X05 (male) (4) - X01 (6) - H13 (7) - V04 (female) (2) or short circuiting with power source Defective swing lock switch (internal short circuit with chassis ground, short circuit with power source) Defective contact or disconnection in wiring harness between C01 ((female) (3) - A2 (female) (1) (2) - H13 (1) - X01 (7) - X05 (male) (3), or short circuit with power source Replace Replace Repair or replace Repair or replace Replace Repair or replace Troubleshooting3 Troubleshooting4 Troubleshooting6 Voltage Measurementcondition BetweenC01(male) (3)andchassis BetweenX05(male) (3)andchassis BetweenV04(female (2)andchassis 0-3V 5sec.afterallleversarereturned toneutral 20-30V Whenswingleverisoperated