TESTING AND ADJUSTING F-1 F-1 BIT PATTERN 20- (1) Swing oil pressure switch does not light up # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the monitoring mode display returns to normal, the problem has been removed. Turn the swing lock switch ON before operating the swing lever. # If there is no display when the lever is operated in one direction, the PPC shuttle valve is defective.
(see H- 5) (When measuring with the engine stopped, charge the accumulator before starting.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. See note 1 Note: it is also possible to fit a short connector and judge the condition. In this case, check the volt- age between C16 (5) and the chassis. If it is 20-30V: Go to Yes If it is less than 1V: Go to NO F-1 Related electrical circuit diagram 20-196 YES 1 Is voltage between 3 YES C16 (5) and chassis Is resistance between normal?
C16 (female) (5) and YES S08, S10 (female) (2) • Start engine 2 normal, and is circuit • Swing lever at Is resistance between insulated from chassis? • H SwO iL nD g : l e2 v0 e-3 r0V NO S an0 d8 , ( 2S )1 n0 o ( rm ma al le , ) a ( n1 d) is • • T Du isr cn o s nt na ert cin t g C s 1w 6i ,t c Sh 0 8O ,F aF ndN SO 10 operated: Max. 1V circuit insulated from • Between C16 and S08: Max. 1 Ω chassis? • Between C16 and S10: Max. 1 Ω • Disconnect S08 and • Between wiring harness and chassis: Min. 1 MΩ S10 NO • Start engine • Lever at neutral: Min.
1 Ω • Swing lever Cause Remedy Defective engine throttle, pump controller Defective contact, or disconnection in wiring harness between S08, S10 (female) (1) and chassis ground. Short circuit with chassis ground, defective contact, or disconnection in wiring harness between C16 (female) (5) and S08, S10 (female) (2) Defective swing oil pressure switch. (If condition does not return to normal even when switch is replaced, go to H-5) Replace Repair or replace Repair or replace Replace