Komatsu — F- 5 Bit pattern 20-( 5) Arm IN oil pressure switch does not light up

TESTING AND ADJUSTING F-5 F-5 Bit pattern 20-(5) Arm IN oil pressure switch does not light up # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the monitoring mode display returns to normal, the problem has been removed. When measuring with the engine running, make sure that the work equipment does not move when the lever is operated. (When measuring with the engine stopped, charge the accumulator before starting.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted.

# Always connect any disconnected connectors before going on the next step. Note 1: It is also possible to fit a short connector and judge the condition. In this case, check the volt- age between C17 (3) and the chassis. If it is 20-30V: Go to YES If it is less than 1V: Go to NO F-5 Related electrical circuit diagram 20-200 YES 1 Is voltage between 3 YES C17 (3) and chassis Is resistance between normal? C17 (female) (3) and YES S05 (female) (2) • Start engine 2 normal, and is circuit • Arm lever at Is resistance between insulated from chassis? • H ArO mL D le:

v 2 e0 r-30V NO S no0 r5 m ( am l,a ale n) d ( 1 is) ca in rcd u ( it2) • • T Du isr cn o s nt na ert cin t g C s 1w 7i t ac nh d O SF 0F 5NO operated to IN: insulated from • Between C17 and S05: max. 1 Ω Max. 1V chassis? • Between wiring harness and chassis: Min. 1 MΩ • Disconnect S05 • Start engine NO • Arm lever at HOLD: Min. 1 MΩ • Arm lever operated to IN: Max. 1 Ω • See Note 1 Cause Remedy Defective engine throttle, pump controller Defective contact, or disconnection in wiring harness between S05 (female) (1) and chassis ground Short circuit with chassis ground, defective contact, or disconnection in wiring harness between C17 (female) (3) - H13 (10) - S05 (female) (2).

Defective arm IN oil pressure switch (If condition does not return to normal even when switch is replaced, go to H-5) Replace Repair or replace Repair or replace Replace