Komatsu — H- 6 Fine control ability is poor or response is poor H- 7 Boom is slow or lacks power

TESTING AND ADJUSTING H-7 H-7 Boom is slow or lacks power # When travel and swing speeds are normal. # Carry out troubleshooting in the heavy- duty operation mode. 6 YES YES Does LS shuttle valve move smoothly? 5 YES Is pump relief pressure normal when boon RAISE circuit is relieved? Check LS shuttle for arm and bucket. NO Is pressure compensation valve normal, or does pressure compensation piston move smoothly? 4 31.9 ± 2.5 Mpa (325 ± 25 kg/cm 2 ) Engine at high idling. Is operating pressure normal when boom LOWER is being operated? 8 YES YES NO 3 It is also possible to interchange with other compensation valve. Note: After inspection, do not forget to return to the original position.

4.9 ± 2.9 MPa (50 ± 30 kg/cm 2 ) Engine at high idling. NO YES Does control valve spool move smoothly? 2 NO YES 1 Is output pressure of PPC valve normal? NO Is pressure switch for boom RAISE, LOWER normal? 306 ± 0.3 MPa (36.7 ± 3 kg/cm 2 ) Engine at high idling. Lever operated fully. NO See Judgement Table Note: If auto- deceleration is cancelled when boom RAISE or boom LOWER is operated, system is normal. (When valve controller related parts are normal) NO 20-216