TESTING AND ADJUSTING TROUBLESHOOTING M-25 M-25 Defective fuel level sensor system. # Remove the fuel level sensor when carrying out troubleshooting. Table Note 1: Difference between fuel level and gauge display. For gauge display position 14 (FULL), the amount of fuel is 78-100 o/o; and for display position 1 (EMPTY) it is below 14,5 o/o. If the chassis is at an angle, the displayed amount of fuel will be different from the actual amount. Therefore, when checking, stop the machine at a horizontal place and wait for at least 2 minutes before checking the gauge. (The display is given a time delay so that the gauge can deal with sudden changes in the fuel level.) Note 2:
There is the possibility of defective installation or interference with the sensor inside the tank, so be careful when installing. Note 3: Check for vibration at the connector mount. If there is excessive vibration, take appropriate action. 20-265 3 YES YES Is there any large crack, chip of 2 damage to float? YES Does arm move NO smoothly? 1 When float is moved up and down, is resis- NO tance between con- nector (1) and flange as shown in table? 4 YES Check wiring harness visually. NO Is it broken? NO Cause Remedy Interference with sensor inside tank. Defective contact of connector. Defective sensor (See note 2).
Disconnection in wiring harness (See note 3) (defective clamp) (external force applied). Defective sensor. Replace (See note 2) Clean connector or replace Replace Replace sensor Replace Top (FULL) stopper position Approx. 12Ω or below Bottom (EMPTY) stopper position Approx. 85-110Ω