Komatsu — DISASSEMBLY OF SWING MACHINERY ASSEMBLY

DISASSEMBLY AND ASSEMBLY SWING MACHINERY 4. Ring gear Remove ring gear (14). 5. No. 2 carrier assembly 1) Remove spacer (15). 2) Remove No. 2 carrier assembly (16). 3) Disassemble No. 2 carrier assembly as follows. i) Push in pin (17), and knock out shaft (18) from carrier (19). # After removing the shaft, remove pin (17). ii) Remove thrust washer (20), gear (21), bear- ing (22), and thrust washer (23). 6. Retainer, collar 1) Remove retainer (24). 2) Set shaft and case assembly in press, push split collar (25) with push tool , and press fit bearing (26). # Operate the press slowly, and press fit the bearing to a position where it is possible to remove the split collar.

3) Remove split collar (25). 7. Shaft assembly 1) Set block to shaft and case assembly (27), then using push tool , remove shaft assembly (28) with press. 2) Remove bearing (26). 30-23