DISASSEMBLY AND ASSEMBLY TRANSMISSION EMERGENCY BRAKE (Refer to page 30-49) Unscrew the screw (1), remove the washer (2) and the flange (3). Unscrew the screws (7) and remove the brake cylinder (8). Keep the brake piston (20) and the seal rings (16-17- 18-19); replace if necessary. Keep the 3 thrust pins (6) and the O-rings; replace if necessary. Do not operate on the screws (5) and the nuts (4), but only in the event of brake release manual intervention. In this case carry out the adjustment setting the screws in touch with the pins (6), then unscrew 1 turn and lock with the counternut (4). Check the disks (10) are not distorted or scorched; if necessary, replace them.
Check the friction disks thickness (11) is not lower than the one specified; if necessary, replace them. Check the groove condition on output shaft and on brake sleeve (12). Check the brake drum (13) and the reaction plate (14) are not worn out. Check the O-ring condition (9); replace, if necessary. Lubricate and use a suitable driver to avoid any dam- age during assembly. Check the Bellaville spring conditions (15). SPECIAL TOOLS Driver for oil seal (9): ref. 119038 Interchangeable handle: ref. 119033 30-35