Komatsu — DISASSEMBLING, SETTING OPERATIONS AND REASSEMBLING

DISASSEMBLY AND ASSEMBLY REAR AXLE REAR AXLE Elastic plugs DISASSEMBLING, SETTING OP- ERATIONS AND REASSEMBLING During the plug assembly and with turbo off, ensure that their notch has oriented towards the stress which is subjecting the thrust. FOREWARD On the contrary, the spiral elastic plugs need no as- sembly orientation. Oil seals for rotating shafts For correct installation of oil seals adhere to the fol- lowing recommendations: Sealing compound Use LOCTITE 510 or types following the specifica- tions. Ensure that both sides to be sealed are clean, dry and totally free from grease and oil.

Before installation soak the seal for half an hour in the same oil that will be used in the axle to be sealed. Clean the shaft and ensure the seal area of the same is not damaged, fitted or grooved. Disassembling - Reassembling The overhauling of epicycloidal group and wheel hubs can be completed without removing the axle from the vehicle. Place the sealing lips towards the oil side. Lubricate the seal lip (oil is better than grease) and fill with grease the space between oil lip and dust lip of dual lip seals. Oil drain Before intervening on axle you have to drain oil from the final drives, from the central gear and from the reduction gear (refer to page 71).

Install the oil seal using a suitable seal driver. Avoid hammering directly on the seal. To avoid damages to the seal lip caused by the shaft: adequately protect the same during shaft assembly procedure. Warning : The exhaust oil disposal must be carried out according to the laws in force. O-ring Removal and Installation of the axle Ensure adequate lubrication of these seals before inserting them in their seats to avoid twisting during shaft assembly. In order to remove the axle, support adequately the vehicle to get a certain safety. Unscrew the fastening nuts and remove the wheels from the hubs. Shims Disconnect the controlling brakes piping, then install some protection plugs.

For each adjustment select the correct shims by in- dividual measurements. Do not trust pack measurement or the thickness in- dicated on the shim. Loose all the remaining connections between frame and axle, then separate the axle from the frame structure. Bearings Installing the axle reverse the order; check for even- tual leakage of oil. For a correct assembly it is suggested to warm them in a furnace from 80oC to 90oC before installation in their respective shafts or to cool them before insert- ing in their respective seats with outer housing. Check the oil level and, if necessary, re-fill. Carry out the braking system bleeding. 30-60