Komatsu — WHEEL HUBS

DISASSEMBLY AND ASSEMBLY REAR AXLE WHEEL HUBS Remove the half shaft (5). Unscrew the screw (1) and remove the wheel carrier (2) and crown gear (3) by using the two extraction holes M12. Separate the wheel carrier from the crown gear and remove the centering bushes (4). Extract the wheel hubs (6). Check the condition of the cassette seal (7) on the wheel hub; replace it, if necessary. Lubricate it an use a correct seal driver to avoid damaging it during the assembling. Check the conditions of the splines on the half shaft (5). Replace the O-ring (8). 30-62