Komatsu — ASSEMBLY OF MAIN RELIEF VALVE ASSEMBLY

DISASSEMBLY AND ASSEMBLY MAIN RELIEF VALVE ASSEMBLY OF MAIN RELIEF VALVE ASSEMBLY Before assembling coat the sliding surface with en- gine oil. # After installing to the control valve assembly, adjust the pressure. For details, see TESTING AND ADJUST- ING, Testing and adjusting oil pressure of work equipment, swing, travel circuits. 1. Install O-ring (17) and ring (16) to seat (15), and as- semble sleeve (11). 2. Assemble sleeve (14) to sleeve (11). 3. Install nut (7) and O-ring (10) to holder (8), then as- semble retainer (9), poppet (13), and spring (12), and install to sleeve (11). # Set contact surface of seat (15) and poppet (13) in position securely. 4.

Assemble nut (4) and O-ring (6) to plug (5), and install to holder (8). 5. Assemble spring (3) and valve (2) to sleeve (11), and install ring (1). 6. Install O-rings (20) and (18), and seal (19) to sleeve (11). 7. Tighten nut (7) to specified torque. Nut: 58.8 ± 4.9 Nm (6 ± 0.5 kgm) 8. Tighten nut (4) to specified torque. Nut: 44.1 ± 4.9 Nm (4.5 ± 0.5 kgm) 30-90