DISASSEMBLY AND ASSEMBLY BUCKET CYLINDER REMOVAL OF BUCKET CYLINDER ASSEMBLY Extend the bucket cylinder piston rod approx. 200 mm, lower the work equipment completely to the ground, then set the safety lock lever to the LOCK position. 1. Set block under arm top. 2. Set block between link and arm, and block be- tween bucket cylinder and arm. 3. Remove lock bolt (1). 1 4. Remove plate, then remove head pin (2). # There are shims installed, so check the number and thickness, and keep in a safe place. 2 5. Start engine, and retract piston rod, then tie piston rod with wire to prevent it from coming out. Release the remaining pressure in the hydraulic circuit.
For details, see TESTING AND ADJUSTING, Re- leasing remaining pressure in hydraulic circuit. 6. Disconnect 2 hoses (3). 7. Sling bucket cylinder assembly, remove plate, remove bottom pin (4), then remove bucket cylinder assembly (5). # There are shims installed, so check the number and thickness, and keep in a safe place. 3 Bucket cylinder assembly: 100 kg. 30-101