DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER DISASSEMBLY OF HYDRAULIC CYLINDER ASSEMBLY (PISTON FIXED WITH NUT TYPE) 1. Piston rod assembly 1) Remove piping from cylinder assembly. 2) Remove mounting bolts, and disconnect head as- sembly (1). 3) Pull out piston rod assembly (2). # Place a container to catch the oil under the cylinder. 4) Disassemble piston rod assembly as follows: i) Set piston rod assembly (2) in tool H1 . ii) Using tool H2 , remove nut (3). # Width across flats of nut. Unit: mm iii) Remove piston assembly (4). iv) Remove retainer (5) and plunger (6). Arm cylinder only. v) Remove collar (7). Arm cylinder only. vi) Remove head assembly (8).
vii) Remove cap (9), and remove 11 ball bearings (10), then remove plunger (11). Arm cylinder only. 30-103 Cylinder Model 1st Boom 2nd Boom Arm Bucket PW130 80 80 85 70