DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER 3. Piston rod assembly 1) Set plunger (11) to piston rod, and assemble 12 balls (10), then secure with cap (9). # Check that there is a slight play at the tip of the plunger. Arm cylinder only. 2) Assemble head assembly (8). 3) Fit O-ring and backup ring, and assemble collar (7). Arm cylinder only. 4) Assemble plunger (6). Arm cylinder only. 5) Assemble retainer (5). Arm cylinder only. 6) Assemble piston assembly (4). 7) Set piston assembly (2) to tool H1 . 8) Using tool H2 , tighten nut (3). Nut: Thread tightener (LT-2). Nut: Unit: kNm (kgm) 9) Assemble piston rod assembly (2). Seal: Grease (G2-LI).
# Set the end gap of the ring at the horizontal (side) position, align the center of shaft and cylinder tube, then insert. # After inserting, check that the ring is not bro- ken and has not come out, then push in fully. 30-109 Cylinder Model 1st&2nd Boom Arm Bucket PW130 5.1±0.5 (520±52) 7.1±0.7 (720±72) 3.3±0.3 (340±34)