Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION Tire size Inflation pressure 18.00R33 aa (if equipped) 0.69MPa {7.00kg/cm 2 , 99.4 PSI} 18.00-33-32PR (standard) 0.56MPa {5.75kg/cm 2 , 81.7 PSI} HD405 Tire size Inflation pressure 18.00R33 aa 0.69MPa {7.00kg/cm 2 , 99.4 PSI} NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa {0.3 kg/cm 2 , 4.3 PSI} of the value in the table above. CHECK WATER SEPARATOR The water separator and fuel prefilter (1) are made one and composed of (2) to (4) in the lower section. 1.

Water and sediment on the bottom can be checked through transparent cap (2). If there is water or sediment, prepare a container to receive it under drain hose (4). 2. Loosen drain valve (3) to drain the water. 3. If fuel starts flowing out through drain hose (4), close valve (3) immediately. DOES BODY POSITIONER OPERATE NORMALLY? 1. Turn the starting switch key to the START position and start the engine. 2. Operate the dump control lever to the RAISE position, then release it. Check that the dump body stops before the end of the stroke. REMARK If the dump body reaches the end of the stroke, the contact of the body will cause an impact.

The body positioner is functioning, so the dump body stops without any impact. 3 - 80 CHECK INFLATION PRESSURE OF TIRES Measure the inflation pressure with a t ire pressure gauge, while the tires are cool, befor Check for damage or wear to t he tires and the rims. Check for loose whee l hub bolts. The proper inflation pressure i s shown below. HD325