. OPERATION OPERATION OPERATION OPERATION 4. When dump lever (3) is moved to the LOWER position, the dump body will start to move down. 5. When the dump body has moved down a certain distance, move dump lever (3) to the FLOAT position. (When the lever is released, it will return to the FLOAT position.) The dump body will then move down under its own weight. may be actuated set to TRAVEL or the impact load on the body is raised, the 3 - 111 NOTICE If the dump control lever is not at the FLOAT si shift lever is not at the N position, the central wa and the alarm buzzer will sound.
On machines equipped with auto emergency ste not fully warmed up, the emergency steeri momentarily when the parking brake switch is dump control lever is operated. When raising the dump body, to prevent an hydraulic circuit or hoist cylinder, let the accele the dump body is near the maximum angle. Regardless of the position of the gear shift lev switch is at the "TRAVEL" position and the du speed range is fixed at 1st. Lower the dump bod The dump control is carried out electrically. If there is any problem in the sensors or valves , a fai lure co de is displayed and the dump body is held in posit ion. If it is desired to move the dump body forcibly for inspection or carry out the operation.
nspecti repair, please ask your Komatsu distributor to PRECAUTIONS FOR OPERATION When traveling on roads in rain or snow, or when traveling on muddy or soft ground, consider th e load ed condition of the machine and be extremely careful n ot to let the tires slip or the machine spin and sink into th e groun d. If the engine should stop when the machin e is traveling, stop the machine immediately, then move t he gear shift lever to the N position, and start the engin e again.
If the central warning lamp and pilot lamp f or any EMERGENCY item on the machine monito r shou ld flash and the buzzer sounds during operation, stop t he machine immediately and investigate the caus For details, see "TROUBLESHOOTING (P When loading, be careful to load the dump body uniformly, and be particularly careful to avoid loadi ng too m uch at the front. On slippery road surfaces, apply the retard er control lever slowly and shift the transmission d own to preven t the rear wheels from locking. When traveling through pools of water, wat er may get inside the front brakes and cause a big drop in the bra king force, so drive carefully in such areas.
If w ater should get into the brakes, apply the brakes s everal times while traveling to produce friction heat between t he pad and disc to remove the water.