Komatsu — METHOD OF LIFTING MACHINE

. OPERATION TRANSPORTATION METHOD OF LIFTING MACHINE WARNING Never try to lift the machine in any posture other than the posture given in the procedure below or using lifting equipment other than in the procedure below. There is a hazard that the machine may lose its balance. 3 - 119 When lifting the machine at a p ort or any other place, always use the following procedure t o lift it. The operator carrying out the lift ing operation using a crane must be a properly qualified crane operator Never raise the machine with an Always make sure that the wire r ope is of ample strength for the weig ht of this machine.

When lifting, keep the machine h Always stop the engine and appl y the brake before starting the lifting operation Never enter the area around or u NOTICE standard specification machine. ing to the attachments and options installed. Thi s method of lifting applies to the The method of lifting differs accord ing to the attachments and options in For details of the procedure for ma chines that are not the standard specification, please consult your Komatsu distributor.

Fo r the weight of the standard s pecification machine, see "WEIGHT TABLE (PAGE 3-120) NOTICE Use protectors to prevent the wi re rope from being cut on sharp corners and t o preven t the wire r ope from cutting into the machine bodywork. ct an ample width to prevent contact with the machine. When using a spreader bar, sele ct an ample width to prevent contact with the m Please consult your Komatsu d istributor before carrying out liftin