. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 125 BEFORE STORAGE rage (more than one month), store as follows. d house the machine in a dry building. Never leave it outdoors. d outdoors, select a flat area and cover the machine with a waterproof sheet. This prevents moisture from collecting. l before storage. the hydraulic cylinder piston rod with grease. When keeping in long-term sto rage (more than one month), store as follo Wash and clean all parts an d house the machine in a dry building. Ne ver leave it outdoors.
If the machine must be store d outdoors, select a flat area and cover th e machine with a waterproof she Completely fill the fuel tank. Lubricate and change the oi Coat the exposed portion of the hydraulic cylinder piston rod with grea Disconnect the negative term inals of the battery and cover it or remove it from the m achine and store i t separately. Apply the parking brake. Set the tire inflation pressure for each tire to within the range of the spec ified inflatio n pressur e fo r the typ e of tire. Push the retarder control lev er forward to the OFF position. the N position and turn the starting switch OFF. OLANT to give a density of at least 30% for the engine coolant.
Place the gear shift lever at the N position and turn the starting switch To prevent rust, fill with CO OLANT to give a density of at least 30% fo r the engin If it is necessary to perform the rus t-prevention operation while the machine is ind oors, open th e doors and windows to improve ventilation and prevent gas poison ing. During the storage period, ope rate the machine once a month to prevent loss of the oil film at t he l ubricate d parts. At the same time, charge the b attery. ipment, wipe off all the grease from hydraulic piston rods. Before operating the work equ ipment, wipe off all the grease from hydrau lic piston r ods.
NOTICE If the machine has been stored wi thout carrying out the monthly rust-prevention operation, c onsult your Komatsu di stributor before using it. When using the machine after long-term storage, do as follows before us Wipe off the grease from the Add oil and grease at all lub When the machine is stored for a long period, moisture in the air will mix with the oil. Check the oil before a nd after starting the engine. If there is water in the oil, change all the oil. PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORAG 1. Check all the oil and water 2.
When traveling after long-t or 1 km to run the machine erm storage, travel forward at a speed of 10 to 15 km/h (6.2 to 9.3 MPH) f or 5 minutes in, then change to normal travel.