. OPERATION TROUBLESHOOTING a towing hook. 3 - 130 This machine must not be towe d except in emergencies. When towing the machine, take the following precautions. When towing a machine, to w it at a low speed of less than 2 km/h (1.2 MPH), and for a distance of a few meters to a place where repairs can be carried out. The machine should be towed only in em ergencies. If the machine must be moved long distanc es, use a transporter. e same class as the machine being towed. Use a towing machine of th Check that the towing mach ine has ample braking power, weight, and rimpull to allow it to control both machines on slopes or on the tow roa d. oth the towing machine and the machine being towed.
Use the specified hook for b To protect the operator if the towing wire or towing bar breaks, install protective plates on both the towing machine and the machine being towe There are towing hooks un under the rear axle (if equip When fitting the towing wire , check the condition of the hook to make sure that there Keep the angle of the towin Keep the angle between the Towing may be carried out requirements for towing. Towing on flat horizontal ro surfaces will require the ma If the pressure in a hydraulic circuit has dropped because of leakage of oil, the parkin g brake will be applied, so release the parking brake b efore towing.
Before releasing the parking brake, always put blocks under all four wheels. If the wh eels are not blocked, there is danger that the machine may move. Connect with the towing wir e or drawbar, and remove the blocks from the wheels wh en the disabled machine is in a condition where it cann ot run away. ation to release the parking brake, check that the surrounding area is safe. sed, the brakes will not work, so pay careful attention to safety. When carrying out the oper ation to release the parking brake, check that the surroun If the parking brake is relea sed, the brakes will not work, so pay careful attention to When towing down a slope, use two towing machines.
One machine should be uphill from the disabled machine and should be connected wi th towing wire or a drawbar to pull the disabled machine b ack and keep it stable. The other machine should tow th e disabled machine downhill.