. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING (1 to 1.5 kgm, 7.2 to 10.8 lbft) NOTICE 3 - 133 It is dangerous to charge a batte ry when installed on a machine. Make sure that it is removed before ch arging. battery, stop the engine and turn the osition. When checking or handling the starting switch key to the OFF p The battery generates hydrogen gas, so there is a hazard of explosion. Do not bring lighted cigarettes n ear the battery, or do anything that will cause sparks. Battery electrolyte is dilute sulfu ric acid, and it will attack your clothes and skin. If it gets on your clothe s or on your skin, immediately wash it off with a large amount of water.
If it gets in your eyes, wash it out with fresh water and consult a doctor . ys wear safety glasses and rubber When handling batteries, alwa gloves. When removing the battery, first disconnect the cable from the ground (normally the negative (-) termina l). When installing, install the positive (+) terminal first. If a tool touches the positive ter minal and the chassis, there is danger that it will cause a spark, so be e xtremely careful. If the terminals are loose, there is danger that the defective contact may generate sparks that will cause a n explosion. When removing or installing the terminals, check which is the positive (+) terminal and which is the neg ative (-) terminal.
REMOVAL AND INSTALLAT ION OF BATTERY remove the ground cable (normally connected to the negative (-) terminal). Before removing the battery, remove the ground cable (normally connected to the nega If any tool touches between t he positive terminal and the chassis, there is a hazard of s parks being generated. When installing the battery, c When replacing the battery, h old the battery securely in position with the battery mounting cla Tightening torque of mounting n After securing the battery, check tha t it does not move. If it moves, tighten it