. MAINTENANCE OUTLINE OF SERVICE 4 - 7 FUEL To prevent the moisture in the air from condens ing and forming water inside the fuel tank, always fill the fuel tank after completing the day's work. fuel containing water or dirt is used, it cannot work properly. when storing or adding fuel. s given in the Operation and Maintenance Manual.
The fuel pump is a precision instrument, and if Be extremely careful not to let impurities get in Always use fuel that matches the temperature If the fuel is used in temperatures lower tha of lower than -15°C), the properties of the fu If the fuel is used in temperatures higher than this may result in a drop in output or other p If the fuel is used in temperatures lower tha n the specified temperature for use (particularly at temperatures el will make it congeal. If the fuel is used in temperatures higher than the specified temperature for use, the viscosity will go down, and roblems.
Before starting the engine, or when 10 minutes have passed after adding fuel, drain the sediment and water from the fuel tank. If the engine runs out of fuel, or if the filters hav e been replaced, it is necessary to bleed the air from the circuit. If there is any foreign material in the fuel tank, wash the tank and fuel system. NOTICE Use only diesel fuel. The engine mounted on this machine employs electron ic control and a high-pressure fuel injection device to obtain good fuel consumption and good exhaust gas characteristics. Fo r this reason, it requires high precision for the parts and good lubrication.
If kerosene or other fuel with low lubricating ability is u sed, there will be a big drop in durability. COOLANT AND WATER FOR DILUTION C) has the important function of preventing corrosion as well as e, the use of antifreeze COOLANT is essential. Komatsu genuine SUPERCOOLANT (AF-NA preventing freezing. Even in the areas where freezing is not an issu Komatsu machines are supplied with Komatsu SUPERCOOLANT (AF-NAC). SUPERCOOLANT (AF-NAC) has excellent anticorrosion, antifreeze and cooling hours. properties and can be used continuously for two years or 4000 As a basic rule, we do not recommend the use o f any COOLANT other than SUPERCOOLANT (AF-NAC).
If you use another COOLANT, it may cause serious p roblems, such as corrosion of the engine and aluminum parts of the cooling system. cautions given in the Operation and Maintenance Manual. r, so it is not flammable. ording to the ambient temperature. e "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-28)". When using antifreeze, always observe the pre COOLANT is already diluted with distilled wate The density used for the COOLANT differs acc For details of the density of the COOLANT, se Even in the areas where it is not considered nec essary to prevent freezing, always use COOLANT with a density of over 30% in order to prevent corrosion of th e cooling system.
oes not contain any ions or water-hardening substances. Never ool before adding coolant. COOLANT is diluted with distilled water that d dilute the COOLANT with ordinary water. If the engine overheats, wait for the engine to c If the coolant level is low, it will cause overheati ng, and will also cause problems with corrosion due to air entering the coolant.