Komatsu — OUTLINE OF ELECTRIC SYSTEM

. MAINTENANCE OUTLINE OF SERVICE STORING OIL AND FUEL oldest oil or fuel first). 4 - 10 Keep indoors to prevent any water, dirt, or other impurities from getting in When keeping drum cans for a long period, put the drum on its side so that the filler port of the drum s is at the side to prevent moisture from bei If drums have to be stored o utside, cover them with a waterproof sheet o r take other measures to protect t hem. To prevent any change in qu ality during long-term storage, be sure to use in the order of first in - fir st out (us e the FILTERS Filters are extremely import ant safety parts. They prevent impurities in the fuel and air circuits from entering using problems. y.

For details, see the Operation and Maintenance Manual. important equipment and ca Replace all filters periodicall y. For details, see the Operation and Mainte However, when working in s evere conditions, replace the filters at shorte r intervals according to t he oil an d fuel (sulfur content) being used. (cartridge type) and use them again. Always replace with new filters. Never try to clean the filters (cartridge type) and use them again. Always replace with new filters. When replacing oil filters, che ck if any metal particles are attached to the ol d filter. If any metal parti cles are fo und, contact your Komatsu distrib utor. filters until just before they are to be used. e filters.

Do not open packs of spare Always use Komatsu genuin OUTLINE OF ELECTRIC SYSTEM It i s extremely dangerous if t he electrical equipment becomes wet or the c overing of the wiring is d amaged. This wil l cause an electrical short circuit and may lead to malfunction of the m achine. Do not wash th e inside o f the operator's cab with water. components. When washing the machine, be careful not to let water get into the electrical Service relating to the electri c system is checking fan belt tension, checki ng damage or wear to th e fan bel t and checking battery fluid level. mponents other than those specified by Komatsu.

Never install any electric co mponents other than those specified by Kom External electro-magnetic int erference may cause malfunction of the con trol system controller, b efore installing a r adio receiver or other wire less equipment, contact your Komatsu distri butor. vent corrosion. When working at the seasho re, carefully clean the electric system to pre When installing an operator' s cab cooler or any other electrical equipme nt, connect it to an indep endent p ower source connector. The cable s to supply power to the optional equipment must never be connect ed to the fuse, starting switch, or battery rel ay.