. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE cup 4 - 24 7. Direct dry compresse d air (less than 0.2 MPa ( 2.1 k g/cm 0.0 PSI)) to the outer el ement from inside alon g its folds hen direct it from outside along its folds a nd again from inside. 8. After c leaning, shine a light bulb from inside o uter element (6) to found, replace the outer 9. Install outer element ( 6) in the air cleaner bod 10. Check that O-ring (9) is fitted to dust cup Next, set so that vac uator valve (8) of dust bottom , and insert it i nto the air cleaner body. (4) is at the 11. Clip h ooks (5) of dust cup (4) to the protrudin g parts of the air cleane r body to lock i