Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CHECK OF INFLATION PRESSURE OF TIRES AND INFLATION OF THEM WARNING HD325 Tire size Inflation pressure 18.00-33-32PR (standard) 0.56MPa {5.75kg/cm 2 , 81.7 PSI} 18.00R33 aa (if equipped) 0.69MPa {7.00kg/cm 2 , 99.4 PSI} HD405 NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa {0.3 kg/cm 2 , 4.3 PSI} of the value in the table above. 4 - 40 When inf lating the ti re, check that no one can ente r the area ar ound the tire, and always use an air chuck w ith a clip that c an be fixed to the air valve.

While infl ating the tir e, check the in flation pressure occasional ly so t hat it will not rise too hi gh. If the rim is not fitted normally, it m ay be broken an d scattered while the tire is inf lated. Accordingly, place a guard around the tire an d do not work in f ront of the r im but work o n the tread side of the tire. f the rim Abnorma l drop of i nflation press ure and abnorm al fitting o rim indicate a trouble in the tire or rim . In this case, be sure to ask a tire repair sh op for repai r. he specified inflation pressure. flation pressure of the tires just after high-speed work.

Be sure t o observe t he specified in flation pressur Do not a djust the in flation pressu travel or heavy-load work. Check Measure t he inflation pressure wi th a tire press ure gauge , whil e the tires are cool, before s Inflation of t ires inflation pressure properly. Adjust the inflation p ressure prop When infla ting a tire, use an air c huck which ca n be fixed to th e air valve of the tire as sho wn in the figure. Do not work in fro nt of the ri m but work o n the tread si de of the ti The prope r inflation pressure is s hown below. Tire size Inflation pressure 18.00R33aa 0.69MPa {7.00kg/cm2, 99.4 PSI}