Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE 4 - 62 5. When installing, tighten until the pac king surface contacts the seal surface of the filte r holder, then tighten it 3/4 of a tu rn. If the f ilter cartridge is tightened too f ar, the packing will be damaged and this will le ad to leakage of fuel. If the filter c artridge is too loose, fuel will a lso leak from the packing, so always tighten th Wh en tightening with a filter wren ch, be extremely careful not to dent or damage 6. After r eplacing filter cartridge (2), loo sen air bleed plug (3), and open supply valve ( Do not loosen the plug at the filter st and of the fuel prefilter. If it is loosened, air is n 7. Fill the fuel tank with fuel.

n wing bolt (5) which is fixing 8. Loose (4). M ove lever (6) up and down t 9. bleedi Tighte primin Tigh ng plug (3) until bubbles do no n air bleeding plug (3) and th g pump (4) securely to lock le tening torque for air bleeding 7.8 Tigh 6.9 to 9.8Nm{0.8 to 1kgm} tening torque for wing screw to 12.7Nm{0.7 to 1.3kgm} 10. After r eplacing the filter cartridge, st for any leakage of fuel from the filter s leakage of oil, check the tightenin cartridge. If there is still leakage of remove the filter cartridge. If there i material embedded in the packin cartridge with a new part and repeat for any leakage of fuel from the filter s leakag e of oil, check the tightenin ge.

If there is still leakage of e the filter cartridge. If there i al embedded in the packin cartrid remov materi cartrid ge with a new part and repeat