. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 50 mm into a out from the vinyl bleeder screw (9) NOTICE level so that it reaches the 4 - 65 Remo (Use a ve the cap from commercially bleeder screw (9) and available vinyl hose.) Put th contai e other end of ner of oil. Loose n bleeder screw at low hose. 23. When secure ly, remove the vinyl hose, then insta 24. Carry out the warming -up operation of the e ngine until the torque converter oil tem 40°. 25. When the torque conv erter oil temperature Front brake: See "BL EED AIR FROM FRO Rear b rake: See "BLE ED AIR FROM REA Do not a ttempt to use the oil drained during air ble eding again.
Such a practice can cause dam equipme Make su re that the oil leve l in the brake oil tank d oes not go down below (H) level in the sight does, th e brake oil pump 26. After fi nishing air blee ding, stop the engine (for 2 to 3 minutes), and adjust the oil specifi ed level. For de tails, see "CHECK O IL LEVEL IN TRANSMISSION CASE, 27. Check the oil level in t he brake sub-tank and adjust the oil level so that it reaches the see "C HECK OIL LEV EL IN BRAKE SUB- TANK, ADD OIL (PAGE 3-75)".