. MAINTENANCE SERVICE PROCEDURE LUBRICATING PARKING BRAKE WARNING 4 - 69 When carrying out ma intenance, raise the bra ke oil pre ssure suffi ciently to p revent the parking brake from being automatically applied. In addition, h ang a warning tag that can be se en clearly t o prevent any other person from op erating the parking brake switch. Do not get any oil or grease on the brake dis c or pad 1. Stop the machine in a flat place and put the blocks under the tires to prevent the machine from moving. 2. Raise the dump body and secure it in position with the body pivot pin. 3.
Before starting operations, raise the brake oil pressure sufficiently to prevent the parking brake from being automatically applied, and check that the brake pressure caution lamp is not lighted up. 4. Release the parking brake and stop the engine. 5. Using a grease pump, pump in grease through fittings (1) and (2) (2 places) in the parking brake body and fitting (3) (1 place) in the slack adjuster. NOTICE Do not use air pressure or oil pressure to carry out high-pressure greasing. 6. After completing the greasing operation, remove fitting (1). If grease comes out, wipe off all the grease that comes out.
REMARK Removing fitting (1) makes it possible to release the abnormal internal pressure created by excessive greasing. 7. If no grease comes out, install fitting (1). Do not use air pressure o r oil pressure to carry o ut high-pressure gre 6. After completing the greasing operation, remove fitting ( If grease comes out, wipe off all the grease that comes REMARK Removing fitting (1) makes it possible to release the abn internal pressure created by excessive greasing. 7. If no grease comes out, install fitting (1). 1. Stop the machine in a flat place and p ut the bl ocks unde r the tire s to prevent the machi 2. Raise the dump b ody and secure it in position with the b ody pivot 3.
Before starting op erations, raise the b rake oil pressure automatically app lied, and check that t he brak e pressure caution lamp is not lighted up 4. Release the parki ng brake and stop th e engin 5. Using a grease pu mp, pump in grease through fittings (1 (2) (2 places) in th e parking brake body and fitti ng (3) (1 p in the slack adjus 6. After completing t he greasing operatio n, remo ve fitting ( If grease comes o ut, wipe off all the gr ease th at comes internal pressure crea ted by excessive gre 8. Check the brakin 4-52)". g capacity. For details, see "CHECK BRAKING CAPACITY OF PARKING BRAKE (PAGE 9.
If the machine mo ves when the braking capacit y is check ed, adjust the parking brake. Fo r details, see "ADJUST PARKING BRAK E (PAGE 4-36)".