. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF REAR BRAKE DISC WARNING for REMARK 4 - 71 Carry out this c heck when the br ake oil temper ature is below 6 0°C ( 140° F). If the disc wear approaches the w ear limit, chec k the condition frequentl y, regardless of the maint enance interval. In ad dition, check the retar der capacity caref Always carry ou t this operation w ith the engine 1. Stop the ma chine on level g round, set th e parking brak e switch to the PARKING pos ition, then check th at the other brakes are not applied before starti ng inspection. 2. Remove cap 3. Push in until rod (2) of the g auge contac ts the piston. Do depress the brake pedal wh en doing this 4.
If slit (3) of ro d (2) goes in be yond guide e nd face (4), it that the disc has reached th e wear limit. If this happe ns, please con inspection a nd maintenance 5. Install cap n ut (1) removed i Tightening to Tightening to rque: 128 to 18 (13 to 19 kgm, 94 to 1 On a new ma chine, the posit ion of the gu ide is adjuste d so that sli t (5) comes to guid e end face (4), so do not loosen locknu t (6) except wh en replacing When the en gine is started a nd the rod is pushed in, th e ro d is pushed back by the br ake cooling oil pressure, so carry out t his operation wi th the engine