. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) CARRYING OUT CALIBRATION WHEN CARRYING OUT CALIBRATION Steps 4 to 6 are additional items to perform when installing new parts, but carry out these steps also to ensure accuracy. 6 - 32 NOTICE Carry out calibration in the following cases. after that. n cylinder has been adjusted. (When the suspension is adjusted.) ss of the machine when empty has changed more than 100 kilograms. replaced. n related parts.
When delivering the machine, and once a month When the oil and gas pressure for the suspensio When the chassis has been modified and the ma ss of the machine when empty has changed more than 100 kilogram When the suspension pressure sensor has been When anything else has been done to suspensio When the condition of the machine as judged by the payload meter is different from the actual condition of the dump truc k. (See the precautions for "DISPLAY DURING NORMAL OP ERATIONS (PAGE 6-21)".) METHOD OF CARRYING OUT CALIBRATIO N (METHOD OF OPERATION) remove all the mud and keep CAL/CLR . (The letters CAL ed reaches 10 km/h In this condition, play changes to the the procedure is p the engine.
RAISE -> LOWER 1. Empty the dump body. When doing this, that is stuck to the dump body. 2. Move the gearshift lever to the N position switch (1) pressed for at least 2 seconds flash) 3. Drive the machine, and when the travel spe (6.2 MPH), press CAL/CLR switch (1). continue to drive the machine, and if the dis time display after approx. 30 seconds, completed. 4. Move the machine to a safe place and sto 5. Start the engine again. 6. Move the dump lever as follows: FLOAT -> -> FLOAT. NOTICE Carry out this operation on flat, level ground. (328 ft 1 in)) of 5 to 10 km/h (3.1 to 6.2 MPH). retained even if the power is switched OFF. Travel in a straight line. (Distance: approx.
100 m When traveling, keep the travel speed to a range The calibration data is stored in the RAM, and is If you want to stop calibration during the operatio n, when the letters CAL in Step 2 are flashing, press CAL/CLR s witch (1) and the display will change from a flashing CAL to a the normal display. During the normal operation display, calibration However, if any errors have occurred on the mach details, see "PROBLEM AND WARNING DISPLAY flashing SCH. Press CAL/CLR switch (1) again and the display will r eturn to can be carried out when the dump lever is at the FLOAT position. ine, for some of the errors, it may be impossible to carry out calibrati on. For (ERROR CODE) (PAGE 6-53)").