Komatsu — CONNECTING EXTERNAL POWER SOURCE

. ATTACHMENTS, OPTIONS EXTERNAL POWER SOURCE TYPE ELECTRIC HEATER source for this heater can be taken from an external commercial power supply to the socket on the side of the machine. immediately after stopping the engine. Power supply to use: 3-phase, AC 230V, 2.7kW through the engine oil pan heater and coolant heater immediately after stopping the engine at the end of the day. This will prevent the temperature of the coolant and engine oil from going down. For engine heater:

230V, 2.7kW 6 - 77 EXTERNAL POWER SOURCE TYPE ELECTRIC HEA When the engine has been st opped, to make it easier to start t he engine again next ti me and to carry out operations, this external electric heater is provided to heat all parts of th e machine and maintai n the temperature. The power SOCKET FOR ENGINE HEATER This socket (1) can be connec ted to an external commercial p ower supply.

If this is done, the en gine oil pan (1 place) and coola nt (1 place) can be heated to make When the ambient temperat expected and that the tempe -20°C (-4°F), connect sock it easier to start the engine next t ure is below -20°C (-4°F), or if rature during the night will go b et (1) to an external power su ime. it is elow pply CONNECTING EXTERN AL POWER SOURCE When the machine is stopped , if it is expected that the temperature will go below -20°C (-4°F), ru n electricity from external suppl y (1) REMARK If the ambient temperatu re is above 0°C (32°F), do not use the engine heater. It will cause premature deterioration of the oil.

When te engine coolant ha s been changed, run the engine at low idling to bleed t he air from the coolant. If there is air in the coolant, the cir culation will be poor and the te mperature maintenance effect will drop.