Komatsu — HANDLING EXTERNAL POWER SOURCE TYPE ELECTRIC HEATER

. ATTACHMENTS, OPTIONS EXTERNAL POWER SOURCE TYPE ELECTRIC HEATER HANDLING PROCEDURE CONTROL METHOD WARNING NOTICE REMARK 6 - 83 This is a starti ng aid to use in seasons when the ambient temperature g oes down to -20 - -40°C (-4 - -40 °F), or even in temperatur es above that if it is difficult to start the engine because o Stop the mac Always chec k that the power switch is at the OFF position. It is extremely dangerous to connect the cable when the power switch is at t he ON position. Check that th e ground connection is securely grounded before turning the p Do not start the engine while the electricity is turned on. Always turn the pow er switch OFF before starting the e ngine.

If the engine is starte d with the electricity still turned on, it will cause failure of the c If the machine is covered with a tarpaulin, the engine startup becomes 1. If it is anti cipated when finishing the day's work that the preheater will be used again at the next r un, par k the machine w ithin the reach of the power unit with an external power input cable. 2. Activate th e preheater several hours before each engine startup, f ollowing the steps below, so tha t the e ngine cooling wa 1) Conne ter and oil in the engine oil pan can be timely warmed u p. hine side with a cable. ct the power unit and the power input outlet on the mac 2) Turn o if it is 3. When pre in the pow 4.

Start the e n electricity with a power switch (main switch) or a separa te power on and off switch of the power unit, provided. heating work is finished, turn off the power switch, disconnect the cable and screw a protective cap er input outlet (receptacle) on the machine side securely. ngine. 3. When pre heating work is finished, turn off the power switch, disco er input outlet (receptacle) on the machine side securely 4. Start the e