Komatsu — BASIC PRECAUTIONS

. ATTACHMENTS, OPTIONS HANDLING MACHINES EQUIPPED WITH KOMTRAX BASIC PRECAUTIONS WARNING 6 - 86 HANDLING MACHINES EQUIP PED WITH KOMTRAX that uses wireless communications. KOMTRAX is a machine management system A contract with your Komatsu distributoris nece ssary before the KOMTRAX system can be used. Any customers desiring to use the KOMTRAX system should consult their Komatsu distributor. The KOMTRAX equipment is a wireless device using radio waves, so it is necessary to obtain authorization and conform to the laws of the country or territory wh contact your Komatsu distributor before selling ere the machine equippedwith KOMTRAX is being used.

Always or exporting any machine equipped with KOMTRAX. When selling or exporting the machine or at ot her times when your Komatsu distributor considers it necessary, it may be necessary for your Komatsu distribu stop communications. If you do not obey the above precautions, tor to remove the KOMTRAX equipment or to carry out action to neither Komatsu nor your Komatsu distributor can take any for any loss that results. responsibility for any problem that is caused or Never disassemble, repair, modify, or move the com munications terminal, antenna, or cables. This may cause failure or fire on the KOMTRAX equipment or the machine itself KOMTRAX.) .

(Your Komatsu distributor will carry out removal and installation of Do not allow cables or cords to become caught; do no t damage or pull cables or cords by force. Short circuits or disconnected wires may cause failure or fire on the KOMTRAX equ ipment or the machine itself. For anyone wearing a pacemaker, make sure that th e communications antenna is at least 22 cm (8.7 in) from the pacemaker. The radio waves may have an adverse effect on the operation of the pacemaker.

Near the blasting jobsite, there may be a danger of unexpected explosion due to use of interactive wireless communication device of KOMTRAX and resulting serious personal If you have to operate the machine within 12 m (39 Komatsu distributor to disconnect power source ca If there are any restriction or law of the territory o restriction or law has a priority than this warning. KOMTRAX specifications are as follows. Rated horsepower: 5 - 10 W Operating frequency: 148 - 150 MHz injury. Make sure to operate the machine away from the blasting jobsite. ft 4 in) from the blasting jobsite or the remote blasting device, ask your ble of KOMTRAX in advance.

r country where the machine equipped with this device is used, such NOTICE Even when the key in the starting switch of the KOM TRAX system is at the OFF position, a small amount of electric power is consumed. When putting the machine into long-term storage, take the action given in "LONG-TERM STORAGE (PAGE3-125)". Please contact your Komatsu distributor before inst alling a top guard or other attachment that covers the cab roof. erminal or wiring.

Be careful not to get water on the communications t REMARK The KOMTRAX system uses wireless commun ications, so it cannot be used inside tunnels, underground, inside buildings, or in mountain areas where radio w cannot be used in areas where the radio signa area. aves cannot be received. Even when the machine is outside, it l is weak or in areas outside the wireless communication service There is absolutely no need to inspect or opera te the KOMTRAX communications terminal, but if any abnormality is found, please consult your Komatsu distribu tor.