Yamaha Exciter II-570 — Engine Assembly and Adjustment

ENGINE ASSEMBLY AND ADJUSTMENT I ENG I ~ I 1. Install: • Stopper ring CD (onto lower crankcase bearing ® (primary sheave side) as shown) @ Knock pin [A] Lower case lID Upper case • Crankshaft assembly (to upper crankcase) NOTE: ______________________ ___ 2. Install: Set the knock pins CD on the upper crankcase and labyrinth seal into the pin holes ® of the bearings and upper crankcase by turning the bearings and labyrinth seal. At the same time, align the bearing punched marks @ with the crankcase mating surface @. The oil seal lip must fit into the crankcase groove. 3.Apply: • Yamabond No. 5® (to mating surfaces of both case halves) 4. Install:

• Dowel pins CD • Lower crankcase CD (onto the upper crankcase ®) NOTE: ______________________ ___ 5. Install: Tap lightly on the case with a soft-head hammer. 5-16 http://ReadManuals.com