Yamaha Exciter II-570 — Cooling System

COOLING SYSTEM ICOOll X I 4. Inspect: • Coolant hoses CD • Heat exchangers ® Crack/Damage ---+ Repace. 5. Measure: • Filler cap opening pressure Cap opens at pressure below the specified pressure ---+ Replace. Cap opening pressure: 80 ... 100 kPa (0.8 ... 1.0 kg/cm2, 11 ... 14 psi) Measurement steps: • Attach the Cooling System Tester CD (90890- 01325, YU-22460-01) to the coolant filler cap® . Apply the specified pressure for 10 seconds, and make sure there is no pressure drop. INSTALLATION Reverse the "REMOVAL" procedure. Note the following points. 1. Tighten: 10 Nm (1.0 m· kg, 7.2 ft ·Ib) Water pump housing bolt: 23 Nm (2.3 m· kg, 17 ft· Ib) Impeller:

14 Nm (1.4 m • kg, 10 ft· Ib) Thermostatic valve cover bolt: 7 Nm (0.7 m· kg, 5.1 ft ·Ib) Fuel tank nut: 2. Adjust: Water pump drive belt deflection (See page 2-11) 3. Fill: • Cooling system (See page 2-7) 6-6 http://ReadManuals.com