______________ C_A_R_B_U_R_~_O_R_I~R~.I ASSEMBLY Reverse the "DISASSEMBLY" procedure. Note the following points. NOTE: ______________________ __ • Before reassembling, wash all parts in clean gasoline. • Always use a new gasket and a-ring. 1. Tighten: Valve seat assembly: 5 Nm (0.5 m • kg. 3.6 ft • Ib) Pilot Jet: 1 Nm (0.1 m· kg. 0.7 ft ·Ib) Main Jet: 2 Nm (0.2 m • kg. 1.4 ft· Ib) 2. Measure: • Float height ® Out of specification ~ Adjust. Float height: 17.1 ... 19.1 mm (0.67 ... 0.75 in) Measurement and adjustment steps: • Hold the carburetor in an upside down posi- tion. • Measure the distance from the carburetor body to the float arm using a gauge. NOTE:
____________________ __ • Before measurement, remove the gasket be- tween the carburetor body and float chamber. • The float arm should be resting on the valve, but not compressing the needle valve. If the float arm height is not within specifica- tion, inspect the valve seat and needle valve. If either is worn, replace them both. If both are fine, adjust the float arm height by bending the float arm tang (Don the float. • Recheck the float arm height. 7-5 http://ReadManuals.com