Yamaha Exciter II-570 — Special Tools

SPECIAL TOOLS II~~~ I~I CIRCLIPS 1. All circlips should be inspected carefully be- fore reassembly. Always replace piston pin clips after one use. Replace misshapen circlips. When installing a circlip CD, make sure that the sharp edged corner ® is positioned opposite to the thrust @ it re- ceives. See the sectional view. 300-001 @ Shaft SPECIAL TOOLS The some special tools are necessary for completely accurate tune-up and assembly. Using the correct special tool will help prevent damage that can be caused by the use of improper tools or improvised techniques. NOTE:

______________________ __ Be sure to use the correct part number when ordering the tool, since the part number differs according to the area as shown below. The first part number is for Europe, and the last part is for the U.S.A. and Canada. e.g. 90890 - *****, YU- ***** FORTUNE UP 1. Sheave Gauge PIN -, YS-91047-A CD PIN -, YS-39501-1 ® This gauge is used to measure sheave distance and for offset adjustment. 2. Fuel Level Gauge PIN 90890-01312, YM-01312-A This gauge is used to measure the fuel level in the float chamber. 1-4 http://ReadManuals.com