I IANOSJP I to) I STEERING SYSTEM/HEADLIGHT BEAM ADJUSTMENT ~ ------------------------------------------------- 2E231 Toe-Out Adjustment 1. Place the machine on a level surface. 2. Check: • Ski toe-out Direct the skis straight forward. Out of specification~Adjust. Ski toe - out ( ® - © ): 0.0 .. 15.0 mm (0.0 .. 0.6 in) t---~ Ski stance @ (center to center): EX570(E)/ST: 920 mm (36.2 in) EX570SX: 980 mm (38.6 in) 3. Adjust: • Ski toe-out Adjustment steps: • Loosen the locknuts CD (tie rod) . • Turn the relay rod ® in or out until the speci- fied toe-out is obtained . • Tighten the locknuts CD (tie rod). Locknut (tie rod):
~ 25 Nm (2.5 m • kg, 18 tt Ib) LOCTITE@ (A] Left side rn:J Right side 2E241 HEADLIGHT BEAM ADJUSTMENT 1. Place the machine on a level surface. 2. Inspect: • Headlight beam direction The high beam should be directed down- wards at an angle of 1/2 0 to the horizontal. If not, adjust the direction. L 3.0 m (10 tt) 7.6 m (25 ft) H 26 mm (1.0 in) 66 mm (2.6 in) 3. Adjust: • Headlight beam direction Adjust the headlight beam by tightening or loosening the adjusters CD. 2-26 http://ReadManuals.com