_ ___________________ IANDSJP(~1 CARBURETOR TUNING . . ~ . 2E271 TUNING CARBURETOR TUNING The carburetor is set at the factory to run at temperatures of O°C - -20°C (32°F - -4°F) at sea level. If the machine has to be operated under conditions other than those specified above, the carburetor must be reset as required. Special care should be taken in carburetor setting so that the piston will not be damaged or seized. In this model, the engine oil is mixed with the fuel just before the fuel enters the carburetors. During initial fuel flow to the carburetor it is not always possible to supply the optimum fuel/ oil mixture depending on the throttle opening.
Therefore, after the carburetors have been tuned or maintained, or after the float chamber is removed for cleaning or jet replacement, be sure to idle the engine for about three minutes in order to avoid engine trouble. Before performing the carburetor tuning, make sure that the following items are set to specification. • Engine idle speed adjustment Throttle cable free play adjustment Carburetor synchronization Starter cable adjustment • Oil pump cable free play adjustment Carburetor Tuning Data ,. Standard specifications (For EX570(E)/ST) ,. Standard specifications (For EX570SX) Model VM38X2 Model TM38 X2 Manufacturer MIKUNI Manufacturer MIKUNI 1.0. Mark (l) 88R-00l (R) 88R-00R 1.0.
Mark 8AYOOl/8AYOOR Main jet (M.J.) # 310 Main jet (M.J.) # 155 Pilot jet (P.J.) # 55 Pilot jet (P.J.) #42.5 Main air jet 02.5 (M.A.J.1 Jet needle 6Fl82-3 (J.N.) Pilot screw (P.S.) 5/8 turns out Air screw (A.S.) 1 1/2 turns out Float height 17.1 - 19.1 mm Float height 21.3 - 23.3 mm (0.84 - 0.92 in) (0.67 - 0.75 in) Idle speed 1,400 - 1,600 r/min Idle speed 1,400 - 1,600 r/min 2·28 http://ReadManuals.com