I POTW R Rio 10'1 DRIVE CHAIN HOUSING AND JACKSHAFT- ~ --------------------------------------------------------- INSPECTION 1. Inspect: • Drive chain housing CD • Cover ® (drive chain housing) • Bearing holder @ Cracks/Damage ~ Replace. • Oil seals @ (drive chain housing) Damage/Wear ~ Replace . • Bearings ® (drive chain housing) Pitting/Damage --} Repalce. • Bearing ® (bearing holder) Pitting/Damage ~ Replace bearing and inner race holder as a set. Replacement steps: • Remove the circlip (J) (bearing holder). • Remove the bearing(s) ® ® using a general bearing puller. • Install the new bearing(s). NOTE:
____________________ ___ Use a socket ® that matches the outside diameter of the race of the bearing. Do not strike the inner race ® of balls @ of the bearing. Contact should be made only with the outer race ®. • Install the new circlip (bearing holder) . Always use a new circlip. 2. Inspect: • Drive gear teeth CD • Driven gear teeth ® • Chain tensioner @ Pitting/Wear/Damage ~ Replace . • Drive chain @ Wear/Damage ~ Replace. Stiff ~ Clean or replace. 4-18 http://ReadManuals.com