_______ E_N_G_I_N_E_A_s_s_E_M_B_~_A_N_D_A_D_J_U_S_T_M_E_N_TIENGI~I PISTON 1.Apply: • 2-stroke engine oil (liberal coating) (to piston pin, bearing, piston ring grooves and piston skirt areas) 2. Install: • Small end bearing • Piston • Piston pin • Piston pin clip • Piston rings NOTE: ______________________ _ • The arrow ® on the piston must point to the front of the engine. • Before installing the piston pin clip, cover the crankcase with a clean rag so you will not accidentally drop the pin clip and material into the crankcase. Position each piston very carefully in its original place. II n! Always use a new piston pin clip. • Do not allow the clip open ends to meet the piston pin slot. 3.
Check: • Piston ring position • Make sure ring ends are properly fitted around ring locating pins in piston grooves. Be sure to check the manufacturer's marks or numbers stamped on the rings are on the top side of the rings. CYLINDER AND CYLINDER HEAD 1.lnstall: • Gasket G) (cylinder) • Cylinder ® Always use a new gasket. NOTE: ______________________ _ Install the cylinder with one hand while compressing the piston rings with the other hand. 5·18 http://ReadManuals.com