Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Seat Belt WARNING 3 - 50 Before fastening t he seat belt, check that there is no problem in the securing brackets or belt. If there i s any wear or da mage, replace. Even if there appe ars to be no problem in the sea t belt, replace the sea t belt once every 3 years. The date of manufact ure is woven on the rev erse side of the belt.

Adjust and fasten the seat belt before operating th Always use the se at belt when operating the mach Do not use the se at belt with either half of the belt Check the mountin g bolts of the belt fitting on t he machine body fo r looseness, and retighten t hem if necess The tightening torq ue for the mounting bolt is 2 4.5 ± 4.9 N·m ( 2.5 ± 0.5 kgf· m,18.1 ± 3.6 lbft). If the belt surface i s scratched or frayed or if th e fittings are broken or d eformed, replace the s Fastening and Rem oving at so that the operator still feels that there is 1. Adjust the se sufficient knee seated, with th 2. After adjusting and tongue (2) (1). Pull on the in the buckle. 3. When removin release it. .

Adjust the se room when fully depressin g the pedal while e backrest. e operator's back against th . After adjusting the seat position, sit in the se at. Grip buckle (1) in each hand and insert ton gue (2) into buckle belt to confirm that the tongue is securely locked g the belt, raise the tip of buckle lever (1) to Fasten belt along your body without kinking it. Adjust the lengths o f the belt on the tongue sid