. OPERATION MACHINE OPERATIONS AND CONTROLS TRAVELING ON SLOPES WARNING Turning or operating the work equipment when working on slopes may cause the machine to lose its balance and turn over, so avoid such 3 - 76 operations. Itis particularly dangerous to s If such operations have to be c wing downhill when the bucket is loaded. arried out, pile soil to make a platform on the slope so that the machine can be kept horizontal when operating. Do not travel up or down steep s lopes. There is danger that the machine may turn over. When traveling, raise the bucke t approx. 20 to 30 cm (8 to 12 in) fro m the ground. Do not travel downhill in rever se. across slopes.
Never turn on slopes or travel Always go down to a flat place to perform these operations. It ma y be longer, but it will ensure safety . Always operate or travel in suc h a way that it is possible to stop s afely at any time if the machine slips or becomes unstable. When traveling uphill, if the sho es slip or it is impossible to travel u phill using only the force of the track s, do not use the pulling force of the arm to help the machine travel uphi ll. There is danger that the machine may turn over. 1. When traveling down stee p hills, use the travel lever and fuel control lever to keep the tr When traveling down a ste equipment to the posture and lower the engine spee avel speed low.
ep hill of more than 15°, set the work shown in the diagram on the right, d. REMARK Travel down fills with the spro If the machine travels down wi tends to become loose, and th cket (1) side down. th the sprocket (1) side up, the track at can cause skipping pitches.