. OPERATION MACHINE OPERATIONS AND CONTROLS WORK POSSIBLE USING COMPACT HYDRAULIC EXCAVATOR 3 - 79 In addition to th e following, it is p ossible to further increase the range of applications by u sing various attachments Backhoe Wor k for excavating places lower than the machine. ipment is in condition shown in diagram on right and link r line of arm cylinder and arm foot pin is at 90°, the g force of each cylinder is the maximum. um use of this angle during digging operations to erating efficiency.
This is suitable for excavating p laces lowe r than the mach When work equ ipment is in condition show n in diagram o Bucket cylinder When the cente r line of arm cylinder and ar m foot pin is at push-out diggin g force of each cylinder is t he maximum. Make the optim um use of this a increase the op erating efficienc The range for e xcavating with t he arm is from a 45° ang le away from the machi ne to a 30° angle toward th e machine. There may be s ome difference s dependin g on the diggin g depth, not try to keep within the above range rath er than operatin g to the end of the cylin der stroke.
Ditching Wor k an be performed efficiently by attaching a bucket Ditching work c which matches the digging operation and parallel to the li ne of the ditch to be excava To excavate a remove the cen Loading Work the swing angle is small, work efficiency can be In places where enhanced by lo cating the dump truck in a pl ace easily visib le to the operator. Loading dump t rucks is easier a nd the loa ding capacity is greater if the hydraulic excavator loads from the rear of the dump truck the side. rather than from