. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 22 4. installed to drai n valve (2) and under coolant drain plug (3) on the engine bloc k. e (2) and drain the water. 5. Open drain valv e (2) and drain the wa Remove drain p lug (3) from the engine cylinder block and drain the water. After draining th e antifreeze solution, close drain valve (2) and tighten drain pl ug (3), then fi ll with clean water. Af ter the radiator is filled with water, star t and r un the engine at l ow idle speed. After the coolant temperature ° F), run the engi ne for about 10 minute 7. Stop the engine plug (3) to drain Close drain valv tighten it. e (2).
Wind seal tapes onto drain plug (3), then 9. Decide the prop ortions of antifreeze a nd wate r accordin g to the table for the mixing rate of water and antifreeze. 10. To remove air i n the cooling system, run the (While doing thi s, leave the radiator c 11. Drain the coola nt inside sub-tank (4), clean the inside midway betwee n the FULL and LOW marks. PC 27MR