Komatsu — CHECK LEVEL OF BATTERY ELECTROLYTE

. MAINTENANCE MAINTENANCE PROCEDURE WARNING the NOTICE When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. When Checking Electrolyte Level from Side of Battery distilled water to a syringe to removed fluid with or battery 4 - 24 CHECK LEVEL OF BATTERY ELECTROLY Perform this check b efore operating the machin Do not use the batte ry if the battery electrolyte leve l is below the LOWER LEVEL line. This will accelerate deterioration of inside of the battery and reduce the service life of t he battery. In addition, it may cause an e xplosion. sparks near the battery.

The battery generat es flammable gas and there is d anger of explosion, do not bring fire or sparks near the battery. Battery electrolyte i s dangerous. If it gets in your e yes or on your skin, wash it off with a lar ge amount of water and cons doctor. ed water to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If oo high, it may leak and cause damage to the paint surface or corrode other parts. When adding distill electrolyte level is t oo high, it may leak and cause damage to the paint surface or corrode o Inspect the battery e lectrolyte level at least once a month and follow the basic safet y procedures given below.

If it is possible to ch eck the electrolyte level from the side of the battery, check as fo llows. VER (PAGE 3-29)". 1. Open the engine rear cover and cooling cover. For details, see "COOLING CO 2. Use a wet cloth to clean the area around the electrolyte level lines and check that the electrolyte level is between the UPPER LEVEL (U.L.) and LOWER LEVEL (L.L.) lines. If the battery is wiped with a dry cloth, static electricity may cause a fire or explosion. . Open the engine rear cover and cooling cov er. For details, see "COOLING CO VER (PAGE 3-29)". to clean the area around th that the electrolyte level (U.L.) and LOWER LEVEL . If the electrolyte level is below the midway U.L. and L.L.

lin the U.L. line. . After adding dist illed water, tighten cap (1) s REMARK If distilled water is a If d lower the level to th e U.L. line. Neutralize the r baking soda (sodium bicarbonate), then flush it amount of water or maker.