Komatsu — REPLACE BUCKET TEETH

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET TEETH WARNING REMARK 4 - 37 It is dan gerous if the work equipment m oves by mistake when the teeth are bei ng replaced. Set the work equipment in a stable con dition, stop the engine, then set the loc k lever securely to the LOCK po sition (L). The pin is knocked out by force, so the re is danger of the pin flying out. Check that nobody is in the surroundi ng area. flying during the replacement There is danger of broken pieces operati on, so wear protective glasses, gloves, and other protective ent. equipm For machines equipped with a cab, t here is only a lock lever on the Replace the bucket teeth before the adapter starts to wear.

t the pin of tooth (1), set the 1. 1. To m ake it possible to knock ou botto m surface of the bucket on a block, check that the work equipment is in a stable condition , then set the lock lever to the LOC K position (L). bucket is horizontal. Set s o that the bottom face of the 2. Use a hammer and drift to knock out lock pin (2). (If the drift is set a gainst rubber pin lock (3) wh en it is hit, the rubber pin lock may break. Set it against the bac k of the pin.) 3. After removing lock pin (2) and ru bber pin lock (3), check them. I f l ock pi ns and rubber pin locks with the following defects are use them wit The lo