Komatsu — CHANGE OIL IN HYDRAULIC TANK, CLEAN STRAINER

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE Rear Cover and Dirt Cover (F), and release the internal plug (P) and drain the oil. plug (P), and if it is damaged, · m (7 ± 1 kgf · m, 50.6 ± 7.2 lbft) that the oil level is between the H and L lines on the sight gauge. cylinder fully as shown in oil filler cap, then install NOTICE control lever to the neutral at a low speed for 2 to 3 4 - 57 5. Open dust cover (1) fully until it (For details of the method of ope the lock, see "In Case of Engi (PAGE 3-28)") 6. Loosen bolt (2), then remove p 7. Remove the cap from oil filler pressure. Set the oil container under the Using the handle, remove dra 8.

Check the O-ring installed to replace the O-ring. After drainin Tightening torque: 68.6 ± 9.81 N T ake care not to get oil on yours elf when you remove drain plug 9. When opening (tilting) the floor , see "When Opening (tilt open) (PAGE 3-31)" for detail 10. Loosen hose clamp (4), remove and take out strainer (7). Remove any dirt stuck to stra diesel oil or flushing oil. If strai with a new one. Secure strainer (7) with bolt 11. 12. secure it in position with hose c 13. After completing the adjustmen t, close the floor. For details, see "When Closing (tilt cl 14. Add the replacement amount of 15.

the diagram on the right, remo the cap and pressurize the insi Be s ure to pressurize the hydraulic tank will suck in air, and this will adversely a 16. positionand run the engine id minutes, then start the normal