. SAFETY SAFETY MACHINE OPERATION BATTERY If you spill acid on your clothes or skin, immediately flush the them immediately with large 2 - 28 BATTERY HAZARD PREVENTION huric acid, and batteries generate flammable hydrogen gas, which may explode. Battery electrolyte contains sulp Mistak en handling can lead to se rious injury or fire. For this reason, always observe t he following precautions. Do n ot use or charge the batte ry if the battery electrolyte level is below the LOWER LEVEL line. This may cause an e to th xplosion. Check the batter y electrolyte level periodically and add distilled water to bring the electrolyte level e UPPER LEVEL line.
Whe n working with batteries, a Nev er smoke or use any flame with large amount of wat If ac id gets into your eyes, flu unt of water and seek me Befo re working with batteries, As ther e is a hazard that sparks will be generated, always do as follows. Do n ot let tools or other metal o bjects make any contact between the battery terminal s. Do not leave tools or other met al objects on top of the bat tery. ve (-) terminal (ground side) first when removing the battery; when installing the Alwa ys disconnect the negati batt ery, connect the positive (+ ) terminal first, and connect the ground last. Tighten th e battery terminals securely.
Flam mable hydrogen gas is ge nerated when the battery is charged, so remove the b attery from the chassis, take it to a well-ventilated place, an d remove the battery caps before charging it. iately. Tigh ten the battery caps secur ely. If any battery cap is damaged, replace it immed Insta ll the battery securely to th e determined place. When doing this, be careful not to let the clamps contact the term inals. e sure that the cover on top of the battery covers the battery completely. Do not let it roll back. e cover is damaged, replace it immediately. Mak e sure that the cover on to p of the battery covers the battery completely.
Do n If th e cover is damaged, repla If the re are chlorides accumula ted on the top surface of the battery or around the te rminals, wash with hot water at a temperature of about 40° C (104°F), then dry completely before installing the w ires.