Komatsu — METHOD OF OPENING (TILTING) FLOOR

. OPERATION DETAILED CONTROLS AND GAUGES When Closing (tilt close) NOTICE 1. Remove lock pin (13) and insert it in storage hole (16). removing lock pin. removing lock pin. 2. Use your left hand to pull floor lock release lever (8) in the direction of the arrow (to the rear) while holding knob (9) with your right hand and pulling it down in the direction of the arrow (approx 45 ° ). NOTICE Tightening torque: 156.8 to 196 N · m (16 to 20 kgf · m, 115.7 to 144.7 lbft) 5. Close engine rear cover (5). 6. Install triangular cover (4) with bolts (3) (M10 x 3).

3 - 34 Beforeclosing the floor, check that t here is no damage or problem in the wiring, piping, orseats inside the floor or revolving frame If any damage or problem is found, please ask your Komatsu distributor t o REMARK If lock pin (13) does not come o Machine equipped with canopy: Machine equipped with cab: Ho When opening or closing the floo r, do not let any part of your body enter the area under the floor. 3. Open engine rear cover (5) fully and secure it in position. (For details of the method of the lock, see "In Case of E (PAGE 3-28)".) 4. Tighten floor tilt lock bolts (6 opening and closing the cover with ngine Rear Cover and Dirt Cover ) (M14 x 6).

REMARK If any bolt (6) is damaged, repla ce it with a genuine Komatsu part o f the same size.