. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Engine Oil Pan, Add Oil WARNING the engine is stopped and may cause serious burns. Wait for the oil the oil level again. 6. If the oil level is correct, tighten the oil filler, then close the engine rear cover. 7. Install the undercover. REMARK 3 - 43 ely after temperature to g o down before performing this operation REMARK ine is at an angle, reposition it to level before checking. If the mach ine is at an angle, reposition it to lev el befor e checking. When chec king the oil level af ter the en gine ha s been operated, allow the engine to cool for 15 minutes before checking. 1. Open the engine rear cover.
e the oil off with a cloth. 2. Remove d ipstick (G) and wip e the oil o ff with a 3. Fully inser t dipstick (G) into fi ller pipe ( F), then remove 4. The oil lev el should be betwe en the H a nd L marks on dipstick (G). If the oil le vel is below the L mark, add oil through oil f iller (F). 5. If the oil is above the H mark, remove th e undercover u nder the in plug ( P), the n check REMARK There is no un dercover installed on the PC There is no un dercover installed on the PC